![]() Run vertical 2x4s from the bottom plate to the existing deck. Start at the bottom of the frame keeping the wood 3 to 4 inches off the ground. Don't screw through the lattice on the sides and divider molding. Beautiful outdoor living, built for life - thats Fiberons low maintenance composite decking, railing, and furniture. Nail 2x4s to existing posts to create the frame needed to secure the lattice panels. Screw the sides and dividers into place the same way as the bottom cap molding. Screw the bottom cap molding, leaving 1/4 inch for expansion between the molding and the lattice. Plastic lattice panels in earthy tones like green and brown to transform the look of your garden or deck. Lattice turned Deck Privacy Screen The longer I live in Oregon, the more I’m aware of some of the preconceived notions there are about Oregonians. Only screw through the lattice when attaching the top cap molding. White or neutral tan vinyl lattice fence panels for a classic looking fence. Don't tighten the screws all the way, to allow for expansion and contraction. 15, 2023 Create a beautiful partition of privacy for your front porch. Screw the cap molding and lattice in place on the top 1-by-3 support boards, all the way around the deck, leaving 1/4 inch between the lattice. Use cap molding on the ends and corners.ĭrill holes for the molding screws every 2 feet, before you attach the molding, so it doesn't crack when it's fastened to the 1-by-3 supports. ![]() Only use the divider molding between two pieces of lattice. Lattice Fence A wood lattice fence is an option if you don’t mind keeping up with painting it but for me, I prefer vinyl lattice as it’s maintenance free. Create a sleek under-decking look by following the right steps Get quotes from up to 3 pros Enter a zip below and get matched to top-rated pros near you. Cut the dividers to the height of the lattice subtracting 1 inch to allow for the cap molding. Cut two pieces of the cap molding the length of the deck, or if it's longer than 8 feet, only cut the last piece to fit on the end.
0 Comments
Leave a Reply. |